Before you start
You need a Windows computer, the Maker ESP32 Pro board, a USB-C data cable and the board's battery pack.
Everything you install is in one shared folder: Advasbot Mind+ — installer and extensions
| File | What it is |
|---|
MindPlus_Win_V1.8.1_RC3.0.exe | Mind+ version 1.8.1 for Windows (about 1.2 GB) |
emakefun-em_maker_esp32-thirdex-V0.0.2.mpext | Blocks for the motors, servos and line tracker |
emakefun-em_ps3-thirdex-V0.0.1.mpext | Blocks for the PS3 gamepad |
Use Mind+ V1, not V2. Mind+ V2 cannot load these two extension files yet. On a Mac or a Linux computer, install Mind+ V1.7.3 from mindplus.cc instead.
Step 1 — Install Mind+
Download the installer and run it. Keep the default choices. It takes a few minutes.
Step 2 — Install the USB driver
The board talks to the computer through a chip called the CH340. Windows needs a driver for it.
In Mind+, open Connect Device and choose Install Serial Driver. Say yes to every prompt.
Step 3 — Switch to upload mode
Find the Realtime / Upload switch in the top-right corner. Click Upload.
Realtime mode runs your blocks on the computer. Upload mode sends them to the board. Advasbot always uses upload mode.
Step 4 — Choose the board
Click Extensions in the bottom-left corner. Open the Board tab and click FireBeetle ESP32-E. Then click Back.
A new category of blue blocks for the board appears in the block list.
Step 5 — Load the two extensions
Click Extensions again and open the User-Ext tab. Click Import user extension and choose the em_maker_esp32 file. Do the same with the em_ps3 file.
Click each extension so it switches on, then click Back. Two new categories appear: and the PS3 one.